Page 1 of 1

mx-60 says "got battery?"

PostPosted: Wed Jan 07, 2015 7:29 pm
by raysubtropical
I have an older charger configured for 48v system and wanted to put it to work on a 24v bank....i hooked everything up and it started charging the 24v bank normally.....a couple days later the 60 amp breaker had tripped.....that's when i learned about pressing key 1 and 3 at the same time during powering up....well i tried the button trick several times...got the full normal display with the old 48v displayed and then it kicks over to "got battery?"

any ideas floating out there on what to do next....? will certainly help ....thank you....