Adding non-flex charge controller

[MCR]

Hi, I want to add (parallel) a single PWM charge controller to our FlexPowerOne system. The PWM controller has it's own breakers- I would like to send the PWM output into the FPO and terminate the pos(+) on the incoming Batt + connector, and the PWM neg(-) output to the same side of the shunt that the FlexMax80 is connected.....this should give monitoring of the power, but I realize the PWM controller will not be "controlled" by the FlexNetDC monitoring device.........does this sound correct or Ok? any opinions....THX!

[sparksalot]

With verified polarity match and proper over current protection in place it would allow you to find out for yourself if it works.

[MCR]

Thanks, yes, we'll find out! Hopefully we don't end up with sparks flying.... :-}