Sunspec status got disabled on MATE3

Mate3 and Mate3s communications devices for Outback Power

Sunspec status got disabled on MATE3

Postby thanhpham on Sun Dec 24, 2017 8:31 am

Hi Guys,

I am trying to connect to MATE3 via Modbus, I have read/write some data from/to the device successfully, but the connection seems not stable.

I did the configuration as below:
* Enable Opticsre
* Enable Sunspec
* Disable DHCP, Data streaming
* IP: 192.168.0.64, port 502

I went to PORT screen while trying to connect to MATE3, I observed that the Sunspec status is READY, and then I started to send command to connect, the Sunspec status changed to Disabled somehow, after few seconds, then it changed back to READY.

Each time it behaves like that, the connection is not successful.

Any one who experienced this problem? Please help me out of this problem?

Hope to get your support soon. Thank you very much and Merry Christmas.
thanhpham
Forum Junior Member
 
Posts: 2
Joined: Sun Dec 24, 2017 8:20 am
My RE system: GE, FN-DC, CC

Re: Sunspec status got disabled on MATE3

Postby thanhpham on Mon Dec 25, 2017 6:40 am

Hi Guys, Finally I can make it works... Thank guys
thanhpham
Forum Junior Member
 
Posts: 2
Joined: Sun Dec 24, 2017 8:20 am
My RE system: GE, FN-DC, CC


Return to Mate3 / Mate3s

Who is online

Users browsing this forum: No registered users and 2 guests

cron