Discuss

Mate3 and Mate3s communications devices for Outback Power
Post Reply
MaxP
Forum Junior Member
Posts: 1
Joined: Mon Sep 09, 2019 10:37 am

Discuss

Post by MaxP » Mon Sep 09, 2019 10:41 am

Hi!

I've brought this up before and have thought of another possible solution. If anyone has any suggestions...

This time of year as the electric heating loads in my neighborhood begin to taper off, I see a rise in AC grid voltage that occasionally prevents my system from selling. However, it's not usually both legs of my two 120 VAC grid inputs that go high. So I was wondering if there's a setting I could change on one of my 2 inverters so that the one seeing the lower voltage walmart survey is permitted to sell while the other, with the higher "prohibitive" voltage, is left not selling.

If this were possible I could funnel my excess generation to the grid through one AC leg, even when I'm normally prevented from doing so when both legs are trying to sell.

Thanks.
Last edited by MaxP on Tue Sep 10, 2019 4:16 am, edited 1 time in total.

Mike Curran
Forum Emperor
Posts: 1111
Joined: Sat Aug 28, 2004 6:28 pm
My RE system: Outback:
- 8 (2x4) Evergreen 180's into one MX60 (2007)
- 6 (2×3) ALEO S79-300's into one FM80 (2017)
- 2 grid-tied GVFX3524's classic stacked for 120/240VAC (2007)
- 12 Surrette/Rolls 2V x 1766Ah (2007)
- Hub10.3, Mate3s, FNDC, RTS, OpticsRE. Tigo Energy ES maximizers on each PV module.

Westinghouse Solar: (2012)
- 30 (2x15) 235W panels with Enphase M215 microinverters, grid-tied.

All self-designed and self-installed
Location: Chagrin Falls, Ohio

Re: Discuss

Post by Mike Curran » Mon Sep 09, 2019 2:53 pm

Looks like you copied and pasted my post from March 26 of this year: http://www.outbackpower.com/forum/viewt ... &hilit=Leg
http://www.tigoenergy.com/site.php?95b2dca2-ca6c
https://enlighten.enphaseenergy.com/public/systems/Hctc107221

Post Reply