Search found 59 matches

by dhamilton
Thu Jun 14, 2012 3:38 pm
Forum: Off Grid Applications
Topic: Using AGS to control Hydro as a generator
Replies: 2
Views: 1298

Re: Using AGS to control Hydro as a generator

I would use the low battery disconnect aux function on the FLEXmax80
by dhamilton
Thu Jun 14, 2012 3:33 pm
Forum: Marine Applications
Topic: Matching VFX3524M and Battery Specs
Replies: 3
Views: 6642

Re: Matching VFX3524M and Battery Specs

For your voltage settings you will want to call your battery manufacture to get those set points. I am assuming that you have your battery bank wired in four stings or four? If that is the case then you have 1200 Amp Hours and your absorb time for the inverter you have will be 5.9 hours. If you have...
by dhamilton
Thu Jun 14, 2012 3:22 pm
Forum: Grid Tie Applications
Topic: SIZING INVERTER
Replies: 12
Views: 8522

Re: SIZING INVERTER

What is the nominal battery voltage you are looking at? Do you have any 240VAC loads or just 120VAC?
by dhamilton
Thu Jun 14, 2012 3:16 pm
Forum: RADIAN Series
Topic: Radian Installation Manual
Replies: 2
Views: 3047

Re: Radian Installation Manual

Have you tried to right click on it and save it to your desktop?
by dhamilton
Thu Jun 14, 2012 3:09 pm
Forum: FLEXmax Charge Controllers
Topic: Only charging on even numbered days
Replies: 2
Views: 1554

Re: Only charging on even numbered days

Have you tried doing a factory reset to see if it was a settings issue?
by dhamilton
Thu Jun 14, 2012 3:08 pm
Forum: FLEXmax Charge Controllers
Topic: Flexmax maximum wattage
Replies: 1
Views: 1345

Re: Flexmax maximum wattage

Hello,

As long as you are under the maximum I do not see a problem with your setup.
by dhamilton
Fri Jan 27, 2012 1:47 pm
Forum: Grid Tie Applications
Topic: Smart RE
Replies: 2
Views: 1842

Re: Smart RE

Tall girl is right in saying that is not how you design a system but I think you're just trying to get a basic understanding of what you may need. I would recommend checking out our string sizing tool on our website. It can be found on the resources page. If you have any other questions please feel ...
by dhamilton
Fri Jan 27, 2012 1:22 pm
Forum: Off Grid Applications
Topic: suggestions for rebulk set point ... and refloat.
Replies: 3
Views: 1370

Re: suggestions for rebulk set point

I like to recommend setting this voltage at 80% state of charge or even one volt below that.

I hope this helps

Thanks,
by dhamilton
Fri Nov 18, 2011 3:37 pm
Forum: Off Grid Applications
Topic: VFX 3024 ( Rolls 4 x 6CS21P) red Light Flashing,
Replies: 10
Views: 3465

Re: VFX 3024 ( Rolls 4 x 6CS21P) red Light Flashing,

Since you have a flashing red light have you checked the Warning screen on the mate or just the error? If you have only checked the error screen try checking the warning screen and see what that says. Go to STATUS>FX>PG2>WARN.