Search found 5 matches

by dmaskal
Sat Feb 01, 2020 12:33 pm
Forum: My OutBack Power System
Topic: Battery Type? For Lithium 48V (Simpliphi)
Replies: 8
Views: 3092

Re: Battery type? For Lithium 48V (Simpliphi)

The FN-DC and FN-DC Comm Port are in two adjacent breaker slots. And I think they are connected. Inverter firmware is 001.006.015 According to application notes this should allow setting LBCO to 50.4V. However I cannot go above 48V. This is bugging me. The system was integrated (pre-configured) by O...
by dmaskal
Thu Jan 30, 2020 4:16 am
Forum: My OutBack Power System
Topic: Battery Type? For Lithium 48V (Simpliphi)
Replies: 8
Views: 3092

Re: Batter type? For Lithium 48V (Simpliphi)

Yes . FLEXnet DC, set to: Charge Termination Y, Auto grid-tie N, Low SOC 20%, Critical SOC 10%.
by dmaskal
Wed Jan 29, 2020 10:01 am
Forum: My OutBack Power System
Topic: Battery Type? For Lithium 48V (Simpliphi)
Replies: 8
Views: 3092

Re: Battery type? For Lithium 48V (Simpliphi)

The system powered up okay and has been running for 48hrs. Conserned about overcharging lithium batteries. Because inverter low battery cut-out voltage will not go above 48V. Recommended is 50.4V @ 130 sec delay. Battery "type" is just an information field and does not change configuration or set po...
by dmaskal
Fri Jan 24, 2020 11:34 pm
Forum: My OutBack Power System
Topic: Battery Type? For Lithium 48V (Simpliphi)
Replies: 8
Views: 3092

Re: Battery type? For Lithium 48V (Simpliphi)

Raysu & Kurt, thanks from your prompt responce. Could only find Upgraded Mate3s (to ver.03.019.001). Hoping recognition of LFP type battery will do some of my configuring. You were correct it does not. I have Simpliphi's integration guide and Notes. I am getting it, slowly. Will configure this week ...
by dmaskal
Mon Jan 20, 2020 6:00 am
Forum: My OutBack Power System
Topic: Battery Type? For Lithium 48V (Simpliphi)
Replies: 8
Views: 3092

Battery Type? For Lithium 48V (Simpliphi)

Greetings. Just setup an OutBack FlexMax system with Simpliphi, Lithium Ferro Phosphate, batteries (LHPl). Is there a software/firware update for FX80 Charge controller to accomodate LFP type batteries?

Did not recieve any information with pre-configured system.