Search found 5 matches

by LAMB
Mon Oct 12, 2015 8:24 am
Forum: Flex Power One
Topic: Flex net DC i
Replies: 8
Views: 10396

Re: Flex net DC i

I absorb at 29.6 volts for 2 hours. I need to top some batteries every week. Bear in mind this is an active system that powers the entire house 24/7. Gets a full charge every day.
by LAMB
Mon Oct 12, 2015 3:44 am
Forum: Flex Power One
Topic: Flex net DC i
Replies: 8
Views: 10396

Re: Flex net DC i

O.K. have checked and reset all my parameters. Getting the green light to come on blinking with a full charge is not the problem, the problem I am having is getting the amber lights to come on as a percentage of the battery condition. The lights are always on (except for the bottom red one) or off w...
by LAMB
Fri Oct 09, 2015 12:51 pm
Forum: Flex Power One
Topic: Flex net DC i
Replies: 8
Views: 10396

Re: Flex net DC i

O.K, I am in the process of reprogramming the unit, will post my findings when finished.
Thanks to you all for your valuable contributions.
by LAMB
Tue Oct 06, 2015 2:13 pm
Forum: Flex Power One
Topic: Flex net DC i
Replies: 8
Views: 10396

Re: Flex net DC i

Thanks guys, Larry are you saying that the LEDs should change up gradually with the state of charge until full charge is met and then the green top led starts to blink, because that is how I assume it should operate. In my case, all the LEDs are on while the batteries are being charged, and once the...
by LAMB
Mon Oct 05, 2015 11:17 am
Forum: Flex Power One
Topic: Flex net DC i
Replies: 8
Views: 10396

Flex net DC i

My Flex net DC is either showing three Amber and one green light while the battery is being charged, and then a blinking green when the batteries are fully charges, no percentage graduation, any ideas.? It has been that way since the unit was installed about three years ago.